Point-of-load DC/DC converters suit 12 or 24V DC industrial applications
Murata Power Solutions
OKI-T/3-W32 PoL DC/DC converters
Murata Power Solutions’ OKI-T/3-W32 series of surface-mount point-of-load (PoL) DC/DC converters is designed to suit 12 or 24V DC industrial applications where a wide input range within a standard package is desirable.
Accommodating an input voltage range from 9 to 32V DC, the converters offer designers the flexibility of using one part to cater for both nominal input voltages.
They are suitable for use in higher-voltage applications that require a lower-voltage source to power FPGAs and microprocessors.
Key specifications
- Typical efficiency of 89 per cent
- Fully compatible with the Distributed-power Open Standards Alliance (DOSA) package specifications
- Measure 11.9 x 20.8 x 8.5mm
- 3A programmable output voltage can be set from 0.75 to 4.5V DC
- Power output at 4.5V out is 13.5W
- Remote on/off input allows the output to be controlled or sequenced
- Under-voltage lock out
- Output short circuit
- Over current and over temperature
- Capable of driving up to 1,000uF ceramic capacitive loads
- Operating temperature from -40C to 85C
- Time and cost savings
- Reduced power-system design risks
- Layout, control-loop stability, noise issues and protection resolved in the module
- Reduced bill-of-materials management and procurement
More stories
DC/DC converters suitable for industrial and telecommunications sectors
The MEE3 series of single output DC/DC converters from Murata Power Solutions are suitable for a wide range of applications within the industrial and telecommunications sectors.
Isolated DC/DC converters offered for telecommunications applications
The UWS series of isolated DC/DC converters from Murata Power Solutions is suitable for a range of data and telecommunications applications.
DC/DC converter from Murata Power Solutions suits use in telecommunications equipment
The UEE series of fully isolated open-frame DC/DC converters from Murata Power Solutions is designed for high-volume, low-cost telecommunications, networking and instrumentation applications.
Murata introduces front-end DC/DC power supply
The new D1U4CS front-end 2,100W DC/DC power supply from Murata Power Solutions, is designed to deliver bulk power to 54VDC distributed power applications.
Regulated bus converter for datacom installations
Murata Power Solutions has launched the RBC-12/17-D48 regulated DC/DC bus converter for applications including 48V-powered datacom and telecom installations, base stations and mobile phone repeaters.
