High-efficiency driver produces uniform white
Maxim Integrated Products
MAX8790
White LED backlight driver has built-in string-current-control circuit to deliver +/-1.5% regulation accuracy between strings, which ensures even brightness for all LEDs.
New from Maxim Integrated Products, the MAX8790 is a high-efficiency driver for white light-emitting diodes (WLEDs).
It is designed for large liquid-crystal displays (LCDs) that employ an array of LEDs as the light source.
The MAX8790 uses a current-mode step-up controller to drive six parallel strings of LEDs connected in multiple series.
This built-in string-current-control circuit achieves +/-1.5% regulation accuracy between strings, which ensures even brightness for all LEDs.
The MAX8790 has a wide +4.5 to +26V input-voltage range and provides a fixed (20mA) or adjustable (15mA to 25mA) full-scale LED current.
The step-up controller uses an external MOSFET for good efficiency, enables scalable output power and maximum operating voltage, and allows a large number of LEDs per string.
Low feedback voltage at each LED string (450mV) helps improve efficiency by reducing power loss.
Selectable switching frequency (500kHz, 750kHz or 1MHz) allows tradeoffs between external component sise and operating efficiency.
The MAX8790 has two dimming control modes to enable a wide variety of applications.
In direct DPWM mode, LED current is directly turned on and off by a PWM signal.
In analogue dimming mode, an internal phase-locked-loop (PLL) circuit translates the PWM signal into an analogue signal and linearly controls the LED current down to 12.5%.
Digital dimming enables average LED current below 12.5% and down to 1%.
Both control methods provide a wide (100:1) dimming range.
The MAX8790 has multiple features to protect the controller from fault conditions.
Separate feedback loops limit the output voltage if one or more LEDs fall open or short.
If one of the feedback voltages exceeds the protection threshold, the controller shuts down and latches off after an internal timer expires.
The controller features cycle-by-cycle current limit, which provides consistent operation and soft-start capability.
A thermal-shutdown circuit provides an additional level of protection.
The MAX8790 is available in a low-profile, thermally enhanced, 4 x 4mm, 20-pin TQFN package and operates over the -40 to +85C temperature range.
Prices start at US $1.95 (1000-up, FOB USA).
A preassembled MAX8790 evaluation kit that contains recommended external components is available to reduce design time.
Request more information
More stories
Maxim offers IO-Link physical-layer transceiver for industrial applicationsdownload
The MAX14821 IO-Link physical-layer (PHY) transceiver from Maxim Integrated Products is suitable for for point-to-point communication between industrial master control modules and sensors and actuators, as well as 24V binary sensor/actuator applications.
Maxim Integrated Products set to roll out line of RFID ID systems
Maxim Integrated Products is introducing a line of RFID keys and cards designed for the automatic identification, access control and electronic markets.
H-bridge transformer creates isolated power supplies in smart grid metering applicationsvideodownload
Maxim Integrated Products has introduced the MAX13256, a H-bridge transformer driver that is designed to provide a simple way to create isolated power supplies in smart grid metering applications and industrial and medical equipment.
Maxim offers stereo audio codec to improve performance and prevent speaker damage
Maxim Integrated Products has introduced MAX98089, a highly integrated stereo audio codec whose small size and low power consumption makes it suitable for portable media applications such as tablets, netbooks and mobile phones.
Offline LED driver from Maxim Integrated Products provides flicker-free dimmingdownload
Maxim Integrated Products has introduced an offline LED driver for industrial, commercial and residential lighting applications such as retrofit dimmable LED lamps and universal LED bulbs.
